Related Articles

A ice box with a automatic ice maker and an integrated water dispenser does practically nothing should you not have water line for connecting to it. Numerous houses have a ice box water supply line set up during initial construction, but this particular feature wasn’t contained in the building that is original of some homes. You are able to re solve this by having an ice manufacturer installation kit which allows one to utilize the plumbing system under the sink. The kit gives you the necessary parts to connect a water line up to your fridge.

Find your water supply lines beneath your sink. You’ve probably three water supply lines underneath the sink; two lines link right to the tap whilst the line that is third to your dishwasher. The valve attached to the proper part associated with the tap may be the water supply line that is cold. Turn the chilled water on the supply line clockwise to shut it.

Connect a drill that is 5/16-inch to your drill. Drill holes within the base case walls to route water line from under the sink towards the backside associated with ice box. Drill as near to the wall that is back of case possible, so that you usually do not lose space for storing within the cabinet.

Thread the water line, contained in the ice manufacturer installation kit, through the certain area behind the ice box to underneath the sink. Keep the water that is excess behind the fridge.

Switch on the water that is cold to strain any water left into the supply line. Use pliers to untwist the faucet supply line through the chilled water supply valve.

Wrap threads in the water that is cold with 2 or 3 wraps of thread-seal tape. Twist the male end of a quick-tee adapter onto the valve. Wrap the thread that is female the contrary end associated with the adapter with thread-seal tape. Twist the supply that is faucet on the feminine end of this adapter.

Slide the compression nut that was included with the kit on the newly set up supply line. Verify the threads are dealing with the end for the line. Thread the ferrule through the kit on the line that is new.

Wrap the rest of see the male threads regarding the quick-tee adapter with thread-seal tape. Insert the water that is new to the opening in the tee. Slip the compression nut on the threads that are male tighten up it from the adapter.

Tighten all three pea pea nuts in the quick-tee adapter with pliers or a variable wrench. Try not to twist the pea pea nuts too tight since this may harm the supply valve, the supply line additionally the adapter.

Place the finish regarding the water line you would like to connect with the fridge into a 5-gallon bucket. Turn the cool water supply valve on underneath the sink. Allow a few gallons of water explain to you the line that is new take away the atmosphere. Turn the supply line off.

Slip the rest of the compression nut and ferrule on the ice box end associated with brand new water line. Link the line to your water line connector regarding the straight back associated with the ice box.

Turn the supply line on yet again. Watch out for leakages after all the connections. Fasten the connections slightly if the thing is a drip. If tightening the bond will not stop the drip, turn the water off, get rid of the connector and include extra thread-seal tape before reconnecting water line.

Plug your fridge in to the wall surface. Coil the extra water line behind the fridge. Drive the fridge resistant to the wall surface.